In this week’s blog we are going to start a new segment entitled “Project Wrap-Up”.  After every project is complete we will blog about it and give you a general idea of what the project detailed, how we preformed the job, any issues that we may have ran into during the job, and before and after pictures that will be coming to our Projects Portfolio page soon.

So we have just wrapped-up a new floating cedar deck with an existing enclosed screen on a porch in Golden Valley. The customer requested that we remove the screening, tear-up existing deck, replace deck with cedar, and then re-install the screening.

1. Our first task was to remove the existing screening without damaging it. We achieved this by carefully removing one section of the screening at a time. The screening was held up with screws that were screwed into the existing deck and also nailed into the fascia. This made it somewhat difficult to remove without ruining the fascia.
2. We tore up the existing decking and hauled it off. This was fairly simple since it was pretty old. We basically just pulled it out with our own hands.
3. We re-leveled the surface & started framing the deck which was very difficult because of concrete that was beneath the old decking. The concrete was cracked and significantly shifted which created an uneven surface.
4. While the deck was being framed with green treated wood, we also started staining both sides of the cedar decking boards. We always stain all sides of cedar board decking to keep moisture from causing the boards to warp.
5. We installed the pre-stained cedar decking boards making sure all our Deck Mate screws were in line with each other. We always use screws instead of nails to ensure that all boards a fastened securely and will not pop out later on down the road.
6. We re-installed the screening. We put the screening back in opposite of how we took it out in order to line everything up properly.

An issue that we ran into during this project was the heat; it was about 80 degrees on average out there. The problem with the heat is it’s just not that fun to work in, well we already know that. The real problem comes when it’s time to stain the decking boards and there is not enough shade in the area. If it’s too hot out during the staining process without ample shade, then the boards do not dry properly.  So a good tip is to try and do your staining early in the morning or make sure you have plenty of shade in the area while staining.

All-in-all, the porch turned out to look very nice and the client was pleased with the outcome. To look at some before and after shots, please check out our photo page. If you have any questions about this project or any future projects please let us know by contacting us.

For now, you can look at the Golden Valley Deck page here until the final page is launched.